eupesco
eupesco
Same here - it does not work anymore :(
Works again!
I am just wondering, because it worked properly for a long time and then suddenly it stopped working. Now when I set a new demand control value in the Onecta...
Message G7 is correct? I did some changes in the Onecta app and here are the G7 messages (after change, there were several G7 messages): Demand off: N0A= / N0A>...
I am setting demand control from 70 to 50 in Faikin, D7 b000 is sent several times. G7 is not changing (it stays N0BC in my case). Error failed-set =...
Yes, it worked perfectly before - I used it a lot with HA automations for example. The only change that was made was the mentioned fw update of the WiFi...
I tried it with another indoor unit. Demand control is 70 according to Faikin (in Onecta 50%): G7 N0ED I set in Faikin to 50: D7 b000 Several changes to...
Sorry for confusion - the firmware update was done on the Daikin internal WiFi-module - nothing to do with Faikin.
I would expect that only WiFi has been updated (due to the changes to Daikin cloud) - I can't say for sure, but I think the SW version of the...
More weird things are happening: I set all units to 100% in the Onecta app and I can see in Faikin MQTT messages 100%. But in the info status MQTT...