Ashno

I'm running into the same issue. It's pretty much unusable due to how slowly it responds. % pygubu-designer python: 3.10.6 on darwin tk: 8.6 pygubu: 0.34 pygubu-designer: 0.38 2024-03-31 11:16:58.799...

FYI - my KinesisBLE fork has those changes. The one issue is the alignment slots are slightly too far apart. The V5 board does not have the alignment slots. [https://github.com/ergodone/KinesisBLE](https://github.com/ergodone/KinesisBLE)...

@tamsky Oops, looks like I didn't push the routed PCB. I'll see if I can find it on my old laptop. I was using auto routing in Kicad so the...

@tamsky The other reasons for the mechanical changes were to get the PCB size no larger than 100mm on a side, to reduce production cost, and move the feather usb...

It's my latest version with the updates above. Just the PCB - I had to order 10 so I have a few extras.

@tamsky email me at [email protected]

I just used the auto route in kicad when I did it. I do have the files I submitted to jlcpcb when I had the board made that I could...