Eric Prouty
Eric Prouty
Near the end of a print a snapshot command was cancelled for an undetermined reason... then it appears to hop between trying to capture the failed frame (1083) and failure...
https://github.com/Enraged-Rabbit-Community/ERCF_v2/blob/master/Recommended_Options/ERF_Filament_Cutter/Stls/2_Toolhead_Sensor/SB_CW2_Body_EBB.stl This piece does not properly trigger the sensor: 1. It has a hole to fit a 7mm ball, not the 5.5mm that is used by option 1 2. The...
On page 22 of the ECRFv2 Manual it shows instructions for wiring the apron LEDs, but then there are no instructions for installing them, is this an oversight or are...
Loving this plugin for easily producing calibration towers. One suggestion is to add support for a kfactor tower. Similar to the temperature tower in shape, but increasing the linear advance...