energiebrand

This is an old issue but now I can confirm exactly the same behaviour on my Sidewinder X1 on a RPi 3B. Problem is, that changes in the filament change...

So here comes a YouTube video I made to show the behaviour: https://youtu.be/kAksutksZ9w Also I made some screenshots of the configuration of the PlugIn as well as I attached the...

In addition... unfortunately after switching off and on the RPi I can see that all configuration are non more existent. So they where not saved! This means you can define...

Hi Joe, thanks a lot for these tips! Especially regarding the xxx.yaml it seems to be easy to manipulate these configurations. However do you plan to examine the behaviour of...

Hi Joe, ok, then it was a misunderstanding! But thanks a lot about your work and your help above!!! I think I will downgrade until a solution will come. So...

OK, I will check the content of the back-up config.yaml. It should contain my buttons from my (re-)configuration I did after I saw that all were gone after the update....

I added a comment in issue #31 because it seems to be the same behaviour like there. Only addition is that still configured buttons are gone. However it is not...

Tested now on a RPi 3B+ with OctoPi 1.4.0 on Octroprint 0.17.0. Same behaviour. So I made here also I downgrade to 0.2.1, copied the relevant backup.yaml code into the...

Well, thanks a lot! Works with the old release currently. If you will rewrite the code would you also please have look on the "Themeify" compatibilty. Not a big issue...

To all above... I droped back to the previous release and this works. However now I have big issues with the Dashboard PlugIn and Display Layer Progress. If I remove...