em1ter
em1ter
[bri3d](https://github.com/bri3d), Thank you for such a rapid and detailed response! Just a notice that confirms your words: Initially the engine code was CJXA (206kW). After I flashed 8S0...B firmware it...
[bri3d](https://github.com/bri3d), Thank you for describing the possible path and solution. I'm really keen to try SBOOT workaround. However for this particular case I lack time and since not having this...
@bri3d , Sorry to bump this thread but I'm not sure if there is any other way to communicate with you and receive your response. After a plenty of time...
@arell50 , Yes, after a plenty of tweaking around with scripts and Brian's and others help I was able to make my RPi to work as BSL flasher and recovered...
@bri3d , Thank you for clarification. Flashing on the bench makes a lot of sense rather than using ODIS with ECU behind the gateway. I was just obeying instructions provided...
Bumping this issue up. Having the same error: Welcome to Tricore BSL. Type help or ? to list commands, you are likely looking for upload to start. (BSL) sboot Setting...
I've dug a bit deeper and here is what I have found. Sboot executed instead of extract_boot_passwords terminates the script with the following error: (BSL) sboot Setting up PWM waveforms......
Downgraded udsoncan to 1.20 and now getting: (BSL) sboot Setting up PWM waveforms... Resetting ECU into Supplier Bootloader... Sending 59 45... None None Timestamp: 1731073075.081290 ID: 07e8 S DLC: 8...
@aarons3 , Thank you, that helped. I even could get seed calculated. However, hit another error: (BSL) extract_boot_passwords Setting up PWM waveforms... Resetting ECU into Supplier Bootloader... Sending 59 45......
@aarons3 , Twister runs pretty slow on my RPi3+. I have gone through manual process to identify the value and it is different all the time: [emiter@emiters-srv Simos18_SBOOT-main]$ ./twister 025748C5...