eduardcabanas

Hi Franc, I have an issue with the library and the MKR GSM 1400. I'm using the following code to check if the connection has been done correctly, but looking...

Hi @FrancMunoz Thank you for your help, but the problem is not if it's connected, I'm installing this arduino in the middle of a field, and sometimes there we lose...

Hi @FrancMunoz Thank you for your help. I modified the library as you mentioned, I uploaded the sketch, disconnect the antenna but with the same result See the code and...

Hi @FrancMunoz There is an error compiling: error: 'readyState' was not declared in this scope Thank's

Hi @FrancMunoz Now it works perfectly!! you are the one... 🥇 by the way, what should I write if I would like to do the same in gprs connection? Thank...

Hi @FrancMunoz Thank you very much for your help, but I found a problem ;-) I'm using the following sketch to simulate the process powering on and off the led....

Hi @FrancMunoz Thank's and sorry to be so bored...but the problem is the same when I put a delay and not a sleep. the first cycle is ok, but next...

Hi @FrancMunoz At last, all works perfect, it was my fault, now is working with your library modifications and with low-power library thank's again Eduard

Hi @holomorph Try to use my code (following) at the end of the loop you could choos to put the arduino in sleep mode or in delay mode Let me...