gnarl
gnarl copied to clipboard
ecc1
GNARL is Not A RileyLink
Hello There is an issue with watchdog timer. it is not reseted in required time. Error: E (2193387) task_wdt: Task watchdog got triggered. The following tasks/users did not reset the...
Hi. I have installed GNARL on my TTGO v1 board and it just disconnects from Loop every 5 minutes. When I try to reconnect GNARL with Loop, it just gives...
Currently testing this out, I've successfully got gnarl running and connected to AAPS and communicating with pump... However, after a while, the gnarl disconnects and the only way to reconnect...
Hello, I have 3 medtronic pumps. One is 712 which works perfectly with Gnarl. The other two are 722 which connect and the connection to the pump constantly breaks down....
hi, I have made tests with the following setup: - Loop (current dev) - iPhone 5s (ios 12.4) - Medtronic pump 522 - CGM (SG from Dexcom share) - GNARL-code...
Here is the output from idf.py monitor: LF file SHA256: a11318f5b2b2730e Rebooting... ets Jun 8 2016 00:22:57 rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:2 load:0x3fff0030,len:4 load:0x3fff0034,len:7076 load:0x40078000,len:13688...
In the beginning, a successful connection via bluetooth to the AAPS occurs. But then after some time (10-20 minutes) the commands from the AAPS to the gnarl do not sent....
When used with a loop, it Disconnect every 5 minutes. Pump RSSI: -55
