RepRapFirmware-SD

RepRapFirmware-SD copied to clipboard

Using the Hemera this setting is an order of hundreds too low for good retractions. This is a big trap for newcomers.

calston

z-jerk was WAY too low (8mm/min aka 0.1mm/sec)

ReneJurack

switching G29 on and off in the toolchange-macros triggers a warning-message "Warning: the height map was loaded when the current Z=0 datum was not determined probing. This may result in...

ReneJurack

Hi, I use one hemera und 2 Titan aero on my TC. The new pull request sets the default steps per millimeter to over 800 steps/mm. I also use the...

smoki3