Michael Karlsson

I can confirm that many controllers (especially cheaper China consoles) sends less than 512channels. 192 for instance. Triggering on break is also good for sync of independent receivers, for instance...

Honestly. having worked with RDM for many years (also being part of the ESTA task group), RDM is pretty basic... From a hardware perspective - if you have a bi-directional...

DMX is specified for up to +6V on either data pin, so unless you know that you're the only one ever driving the bus, expect 6V (at least 5V would...

Has there been any more progress on this to get it to show up in the Addon Store?

Ok, after a reboot or two it all of a sudden showed up

Honestly - you should not… If it takes 6ms to respond from the end of your request it is not even close to being compliant. Most professional controllers would have...

Probably the device writes the new DMX start adress to some NVM before responding - hence not doing it in time and responding outside of spec, instead of responding with...

Oh, and about how common it is with sub-devices… It’s not super common, but it’s not uncommon. RC4 uses sub-devices in LumenDim and similar. Zero88 uses it in their BetaPack...

It's very varying... Almost all major manufacturers have RDM in their fixtures and consoles (even MA Lighting has it these days). Many small devices use it to avoid having an...