duncan

yes all buttons work,this is only pcb desighn,i use it as a little allarm clock and it seems to use a 300mah battery overnight even when screen is off,if i...

There also a driver issue,may have to install the zedig driver libusbK i had to with 1.8.1 and 1.8.2

Ye its not implemented thats why i dont think.you have to do it by the cmd

So where is all this info so we dont keep asking? is it publishe anywhere? it may help to make some pdfs of all the tools etc blink1-tool and linkM-tool,i...

Hi,just want to know what you used to send commands to the blinkM mk2 experamentation boards etc does it work with the blinkM mk1 arduino loader? via cmd for e.g

Hi what was the problem with resistor, my backlight doesnt work when using mp3 player, also most firmware. My resistor value says 100. Witch is 10 ohm i think, do...

2boots-arduino-atmega328p-16000000L-PD4.hex is the hex ive loaded via isp ime using arduino uno,ive tryed two uno with same results.is boot flash size 2048 and is boot reset vector enabled? ive tred...

Also will the sd card boot option work with attiny? i know serial wont work?

In file included from C:\Users\DUNK\AppData\Local\Temp\arduino_modified_sketch_780485\seirlight.ino:324:0: sketch\circnoise_pal_1.h: In function 'void circnoise_pal_1()': sketch\circnoise_pal_1.h:14:19: warning: large integer implicitly truncated to unsigned type [-Woverflow] uint8_t scale = 1000; // the "zoom factor" for the...