Doug Scott

> Converted my Ender 3 Pro to 32 bit MKS SGEN v1.0 (not SGEN-L). Upgraded the display to MKS TFT 32. The drive on the TFT is available but the...

By "configured them in Marlin" are you talking about the #define X_DRIVER_TYPE TMC2209 entries for x, y, z and e?

My x-axis stepper is silent, my y-axis hums. Its mounted in one of those plastic adaptors so it can be mounted to the frame. I think that is creating the...

Finally getting to this. I only need to change the line you have outlined to "#define NUM_Z_STEPPER_DRIVERS 2"? No other changes? I am using the 3DTOUCH probe for z-axis endstop,...

> With regards to the motor vibration, I'm unable to eliminate the z-axis motors missing steps and crashing into the platform when performing quick moves in Dual-Z Mode. Slower or...

> > I've tried running both or either one with a 1 screw and none, The issues occurs so long as two motors are connected, even with no screws attached,...

> Have an issue with 3d touch sensor The same issue is also present if I use any SKR board or MKS series board. As far as I have found...

> Well the part where auto leveling dont work shod be easy to see the z axis dont move except for layer change and the part where i am sure...

I am not a developer or programmer, will never make any programming changes, but, in the .config folder there is a file called preferences.ini, open it and change "language =...

My TFT35 e3 v3 started doing the same thing the other day, creating the semaphore file in the root of the SD card started the screen calibration function. Just the...