Dirk Beer

I had the same problem on a Raspberry Pi. Another solution is to replace `DWCMD="bash -c 'rtl_fm -f 144.39M - | direwolf -c sdr.conf -r 24000 -D 1 -'"` with...

I have this same problem.

With debug info: `pi@sdrpi:~ $ rtl_test` `libusb: error [udev_hotplug_event] ignoring udev action bind` `Found 1 device(s): 0: sdrplay.com, SDRplay_RSPII_VID_1DF7&PID_3010_BUS_001_PORT_003, SN: 170802A220` `name for 0-th device = SDRplay_RSPII_VID_1DF7&PID_3010_BUS_001_PORT_003` `Using device 0:...

Ok, interesting. Thank you for your investigation, and for your work in creating this wrapper. I don't care about rtl_test either, just thought that its output might be most diagnostic....

Ok, thank you - good to know that mqtts should work. Will remove hloctopic. I'm on meteoscientific.com username: [email protected] DevEUI caf8171d7be55959 application id: f205203f-d091-4ab7-84fb-347e487061d8

1. It's on Nik Hawks' meteoscientific.com / Gristle King Inc 2. Yes, correct, and I can send Hex 030101 from the console and that switches the device as intended

Paul, Thanks the troubleshooting. Unfortunately, I still can't get it to work. My device sends an uplink every ten minutes. I wait for it to send an uplink, then I...

It's working for me, too! Also no changes to the configuration on my side. Thanks, Paul. Ticket can be closed as far as I'm concerned.

Ok, I take it back. Added another device, identical HTTP Integration MQTT setup, same problem. Device uplink data shows up on huptopic every few minutes as scheduled. The device responds...

Hi @disk91, thank you for fixing this. Would you please tell me what exactly you fixed, so that I don't do it again? For each Application HTTP mqtt Integration, I...