David Goadby

It seems so. I use this so did wonder if Frank would agree to it being forked or transferred to someone who is active in the group. There are a...

I am just upgrading my K40 to a GCODE controller so will be looking to use this software. After I have finished the upgrade I will see if I can...

I am about to replace the controller in my ageing HPC laser and I have downloaded the sources to see what can be done. Assuming this account stays open then...

The circuit diagram shows two 0 ohm resistors (aka links). To use an external antenna via the Apex socket you need to remove R11 and add a link to R10....

Well, it doesn't look logical but the PCB tracks may not be going in a logical way. I am expecting that you will need to remove one link and add...

Which ADSB antenna are you using? The problem is probably due to the polar response of the aerial. Aerials are always a compromise and, at these frequencies, proximity to buildings...

Well, my first antenna was a cheapie whip but that was a waste of time. It was a small whip with a magnetic base. In truth it did not even...

I took a look at the code in dump1090.c . The SDR reads are done in a background thread using a callback "rtlsdrCallback" which is set in "readerThreadEntryPoint". The easiest...

If you have not specifically installed it this will help you: [http://dockerlabs.collabnix.com/intermediate/workshop/DockerCompose/How_to_Install_Docker_Compose.html](http://dockerlabs.collabnix.com/intermediate/workshop/DockerCompose/How_to_Install_Docker_Compose.html) or here: [https://docs.docker.com/compose/install/](https://docs.docker.com/compose/install/) . Of course I am assuming that the Docker Engine is already installed.

Did this ever get fixed? I just started to use PM2 and the keyboard interrupt problem is a big headache for me. I am not using watchdog. A few hours...