SwitchBot-MQTT-BLE-ESP32
SwitchBot-MQTT-BLE-ESP32 copied to clipboard
devWaves
Allows for multiple SwitchBot bots and curtains to be controlled via MQTT sent to ESP32. ESP32 will send BLE commands to switchbots and return MQTT responses to the broker. Also supports Temperature,...
Is the Fingerbot Bot supported or only the switchbot? I added the Bluetooth adress it in the "Switchbot Bot Settings" part, but it does not work. Are there plans to...
Any thoughts on supporting the new Blind Tilt? I had hopped that it would work as a curtain, but no such luck that I can tell. I'm happy to be...
I love this project and have it working perfectly with HA, switchbots, temp and light sensors but I wanted to also use the switchbot remotes. I couldn't tell from the...
Just unpacked my fancy new Switchbot Curtain devices (using two in a pair) and the Switchbot setup flow included an OTA to firmware v6.0. Only now did I find this...
First off THANKS. I love this code. Just got my first Switchbot product ever a few days back. A bot. A black one. It's on my Sony amp controlling the...
Hi, firstly thanks for the integration it works fantastic. However I was wondering if it is possible to open just one side of a dual curtain setup? My switchbots are...
Hi all, I tried to add my switchbot, but it doesn't add. I have downloaded all the libraries mentioned, I only see the WiFi signal esp32 sensor.
Hello. I see the "sensor.esp32_linkquality" (Entity in Home Assistant) that is the WiFi signal of ESP32 shown as "rssi". I suggest to modify it to "dBm", since the "Unit of...
I am getting this output when i run the sketch in Arduino-IDE on an Esp-Wroom board "wifi:timeout when WiFi un-init, type=4". The wifiscan sketch example works.
Hello dear team, I have been trying for hours to flash my ESP32 via Arduino ID exactly according to the instructions. Unfortunately, I always get an error message when checking...
