Philip Oettershagen comments

Repositories
Issues
Comments

Results 5 comments of


                                            Philip Oettershagen

Shortcut Ctrl+] not accessible on all keyboards

Thank you for picking that up! I see the problem, though.

Occasional freeze while running

Yes, WebUI only. I'll try and report back 👍

Occasional freeze while running

I ran the same G-Code file from the SD card over Telnet: `$SD/Run=/pinguini4-300-3500-knitter.nc` WebUI was not loaded. A freeze occured again, but the stepper motor was not interrupted during motion....

Occasional freeze while running

You are right Mitch, here is the file: [pinguini4-300-3500-knitter.nc.zip](https://github.com/bdring/FluidNC/files/10333230/pinguini4-300-3500-knitter.nc.zip)

Occasional freeze while running

Tested under 3.6.6 (WebUI) with the same issue. Ran with the attached GCode. [drill_300_holes.nc.zip](https://github.com/bdring/FluidNC/files/10518968/drill_300_holes.nc.zip)