David Buezas
David Buezas
I see you have `S_CURVE_FACTOR` enabled so I suppose you are using #27101. That's the only thing I see that could affect it. SmoothLA uses specific code to integrate with...
I assume you u are testing directly from bugfix, right? Also with NLE disabled during build. I don't know what could be the issue, I can't reproduce it :/
I use an skr3, I do have SCurve enabled (but not the special one in an open MR) The only thing I can think of is trying higher micro stepping...
It is just a guess, if the problem goes away at higher microsteps it would be a good clue
Time to jump to ftmotion, that's the best option at the moment
> ftmotion fixed all my problems, thanks. Happy to hear! Make sure to update once #28192 merges, otherwise long prints start torturing the extruder
@vovodroid It is super easy to implement in ftmotion, I would do it but I don't use the feature so I'd probably not test it well enough. I think this...
In short: the opposite.
It shouldn't. I didn't put much thought in the code hehe
Need to test this properly