David Oswald

Hi @SLiNv yes this is correct - however as you can see from this thread the underlying ISO15693 support *is* there, so if someone feels like picking up the implementation...

This is great @nvx - is there a PR to the RRG repo that you can post here? As the codebase is indeed very similar, it might be possible to...

@wupalogic As @maxieds said, most likely you will run into timing issues if you try to do what you describe over USB. Many readers are quite picky. I don't think...

Dear @nov3mb3r, can you check in the dev mngr that the atmel drivers are installed and that the chameleon is really in the bootloader (i.e. shows up as Atmel DFU...

@lvandenb that looks like expected behavior: the bootloader is a USB device but does not emulate a COM port. The normal firmware shows then up as COM8 in your case.

Hi @maxieds and @ceres-c, yes a separate PT for the logmode functionality would of course be great. Independent of that, we'd definitely consider also merging the DESFire code at some...

Hi, As you can see in the schematics, if the power switch is off the battery is only connected to the charger IC:  So I would check how that...

You can take out the battery and then measure the resistance between battery + and - This should be high impedance / constantly increase, otherwise there might be an issue...

Yes, so this looks like there's no low impedance in the cap or charging IC - just to make sure, does it go up further than 3.8 M? (this will...

It's in Eagle, but there is also a PDF in the folder so that you don't have to install that just to check the schematic.