Daniel Nilsson

Strange, my display (SW102) seems to determine inactivity based on speed sensor reading report which seems pretty logical, wonder what that display uses then..

I have no clue what could cause this, I don't have that display so I will not be able to investigate

But we can leave the issue open and maybe someone with that display and issue can find the cause

I have no clue. I would expect the 36V BBS02 controller to have the same hardware as the 48V but I'm not sure. I have only tested this on 48V...

Sounds like the configured lower voltage limit is too low for your throttle, try increasing it to maybe 1200mV Disconnecting and then reconnecting the throttle while powered on with this...

If you previously had 600mV you had changed it yourself, default is 900mV which works for most throttles. 0x100 means braking so that's completely normal, not really an error though....

Yes the speed issue is known on BBS02, it's tracked here #114. Gear sensor code it maintained by community, there was some changes merged in this version, maybe it's broken,...

It's a BBS02 specific issue and I don't have a BBS02. I don't think anyone is working on fixing it to be honest, so don't get you hopes up..

@dav0000000 I don't think so but could be worth a test. It was done that way so that if you called system_ms() while having disabled ET0 outside it would not...

Sorry I'm busy, I'm 99% sure that is not the issue anyway. Build instructions are here https://github.com/danielnilsson9/bbs-fw/wiki/Build-from-Source if you want to try yourself