David Andrzejewski

directrtp=on - no audio

7

This may be a configuration issue, but I can't get audio between two 7971s with directrtp=on. **Reproduction Steps:** 1. set directrtp=on 2. make a call between two phones **Expected behavior:**...

Manual: Section 3.5.1 ("The rflog file") does not refer to 'd' status

3

aprx can log R, T, or d. d should be documented.

SSn-N not supported correctly.

4

I want my digipeater to support OH7-7. So I configured it as such: ``` source $mycall viscous-delay 1 maxreq 3 maxdone 3 keys WIDE,TRACE maxreq 7 maxdone 7 keys OH...

iOS Widget

5

**Describe the solution you'd like** I would like an iOS widget that contains information about my printer and the current print. Progress percentage, ETA, and perhaps a frame from the...

Added slightly-modified 1_Left.stl for Ender 3 S1

1

This is my modification to `1_Left.stl` that fits my Ender 3 S1. CAD software is not my specialty, so I simply modified this in my slicer. Only one of the...

EXT_FNCT calls from REST API are sent to other peers

1

When executing REST API calls - such as inhibit or radio check - against an individual dvmhost peer, that peer sends those to other peers. I asked about this on...

On Debian bookworm, the aprx service immediately dies after starting unless the service type is set to `forking`. I also added a .service file to the debian directory... although I...

Added gain figures to 915mhz fixed and mobile antennas, added radiation pattern to 915 fixed antennas.

1

This adds gain figures for the 915mhz fixed and mobile antennas, retrieved from the manufacturer or storefront. Also adds radiation pattern to the fixed antenna table.

Document available column names for `--nodes` table

1

Now that the `--nodes` table can be configured with `--show-fields`, and soon sortable (see #740), it would be helpful to document the fields available. We'd want to automate this as...

Add a CLI param to make the `--nodes` table sortable by any of the columns being displayed.