Doug Mercer

Thanks for suggesting these changes. Since the default colors can (should be changed) by users in the alice_init.ini your suggested color changes will not be included as the defaults in...

Hi: Please remember you are submitting pull request that fundamentally change the master copy of the source code through this means. If you just want to show the developers some...

Here is another capability that we should think about adding in the firmware. After creating over 100 labs for M1k it has become apparent that, with one or two notable...

@dbogdan, any thoughts on this? Should I wait for this to be fixed or reload both of these Rev F M1K boards I have been testing with v 2.09 as...

I think I'm seeing that the channel B current settings are not actually making it in correctly. Other wise I would not have been so totally confused and posted issue...

I'm still testing things. I'll get back to you is I find anything. Doug On 1/15/2018 3:08 PM, Dragos Bogdan wrote: > > Unfortunately, we didn't find what can cause...

Just trying to be helpful here but it would seem to me that you could narrow things down a lot by comparing what you changed between 2.15 (works) and 2.16...

I might be mistaken but I think I just tested a board ( HW Rev E ) newly loaded with 2.15 and loaded an existing set of cal values from...

I tested the following version of the firmware to see at what point the write to calibration settings broke. 2.10, 2.11. 2.12, 2.13 ( didn't have 2.14 handy ) all...

I think that was an incorrect assumption and trade-off. There are thousands of the original boards out there that were never "factory" calibrated and there are more than 1000 of...