LegacyCura
LegacyCura copied to clipboard
daid
Read this, it's important! NEW CURA DEVELOPMENT IS HAPPENING AT https://github.com/Ultimaker/Cura, this is the Cura 15.04 archive. Cura 2.1 and newer is on the Ultimaker github.
Hi, I have a square hole in a project and the hole is rotated 22.5 degrees to miss some blades on an impeller. I cannot seem to get other than...
Hi, Can anyone explain the settings which is displayed in gcode after the line ;TYPE:SKIN **G1 F1740 X73.01 Y100.936 E798.12148** Where are these settings made in cura. Thanks
My custom printer is having issues printing SKIN types. My printer (basic and custom made) only prints when there is an E command on the line. I **can not** send...
is it possible to make diferent thickness for different layers? (like Slic3r 0.9.9 has)
I get identical G-code with flow compensation at 100% and 5%. I tried the same experiment on a Windows PC, also with 15.04.xx and saw the expected change in E-numbers.
I don't know how to discribe the ... I can see the model, but the Time shows '0 minutes' or nothing, and Nothing in the Layers Part, only show 1...
I have no clue why this is happening. When i loaded a file that normally takes about 10 min to print it says 1500 hours. Ive tried just about everything...
I updated to build 15.04.2 and when i cancel a partial print, I can no longer move the nozzle out of the way to clean the print bed. There used...
Hi, I have a problem on Cura 15.04.6 When I set my infill, I either choose 10 percent or 100 percent, the result will always be the same : 100...
