Christian Herzog

> Did encodeded_extent_max change? or discard? between the two `bcachefs-utils` versions you mean? Not unless the default changed, I always use the same parameters.

``` 1.4.0: encoded_extent_max: 64.0 KiB Discard: 0 v0.1-730-g28e6dea: encoded_extent_max: 64.0 KiB Discard: 0

small update: 6.9 is back to 6.7 levels (even a bit higher), but still a good ways from August 2023.

I have the same issue with a UE50MU6170

> **Workaround Implemented (via `udev` rule):** > > To resolve this, a `udev` rule was created to forcibly unbind `hid-sensor-hub` from the `hid_device` associated with USB Interface 3, and then...

thanks for your suggestions! I'll look into the STL -> STEP conversion, but I still think it would be nice if the OpenSCAD part were usable... I realized what the...

ok by increasing the rendering limit in the OpenSCAD settings and commenting out `assert(_useReversedBelts==true || test==true);` in `assemblies/MainAssemblyRB.scad` I got the model to render!

Dear Martin, thanks for the good news. I'll definitely wait for the new version then. It's a long-term project and I haven't ordered a single part yet. I'll be happy...

great news. I'm not too concerned re: RF blocking - you can always route a thin U.FL coax cable and slap the antenna to the outside. what thickness of CF...

ok I talked to our workshop chief. There is a waterjet cutter at our university, but not in our department (they hope to get one next year), which makes access...