csanii123

I didn't have any issues with my basic multi-color prints and layer adhesion. Do you have any issues when doing non-multi-color prints ? Perhaps you don't have your bed close...

Basic pen test files for #1 that you mentioned. [Pen_tests_Cyrus_Sanii.zip](https://github.com/Sakati84/3DPrintColorizer/files/7110140/Pen_tests_Cyrus_Sanii.zip)

Just eyeballing the centers for the pens using Cura and I see about 41mm for 2-3, 4-5, and 6-7 and about 27mm for 3-4 and 5-6.

If you go 1 directory up you will find a Software directory. In there is the Python code that does the post processing of the gcode to do the coloring.

I was able to make this work on my stock Ender 3 v2 with firmware v1.0.2 You need to follow the software setup instructions as that inserts the pen pickup/return...

I have not tried with Octoprint. I copied the file direct to an SD card and used that. In theory it should work the same for Octoprint as all it...

I honestly never played with the max z-speed as I wasn't sure if it would cause issues with my printer. With a non-stock firmware you might be able to adjust...