combolek

I am not sure if this is your problem but the software shutdown function has quite a long delay (not sure exactly but on the order of 10 seconds) so...

There is already a separate ticket for the TFT35 connection (issue #6).

I don't have skr 1.3 but I am trying it with skr pro 1.1 and cannot get it to work either. But the relay module works fine when controlled by...

Hmm, I was trying different pins and on SKR PRO they are quite generic and endstop pins can send signal if you configure them for output. I verified with multi-meter...

> How do you controlled it with the raspberry pi You have to connect ground and two GPIO pins from RPi to the relay. I use pins 6 (GND), 8...

Yes, these should work.

You can use something like this: https://www.aliexpress.com/item/886978271.html (the momentary 24V version). It has 5 contacts/wires. Connect the `+` and `-` wires to the `V+` and `V-` output terminals of the...

I do not see the 3A anywhere but this must be the rating of the switch itself. The actual current is going to much less because it's only connected to...

I have it working with Klipper on SKR 1.4 Turbo. I connected it to PWRDET header. In printer.cfg I have this: ``` [output_pin ps_on] pin: P1.0 value: 1 [gcode_macro M81]...

> that doesnt work, the pin from the RPI have not enugh power to hold the on signal It works for me, I use it all the time. Maybe it...