Patrik Mayer

As I've obviosly bricked my SKR 1.4 Turbo, can someone point me to the **bootloader.bin** for it? It's an LPC1769 thus the SKR 1.1 bootloader won't work. Also its difficult...

Oh, I'm sorry. I did not see this when writing my comment. Thank you!

Sorry... *did not* see it.

I'm in the same boat as @Ed-EE-Eng. Exactly the same issue. Thus I'm searching for the LPC176**9** bootloader to try to reflash it. Does someone have the suitable bootloader for...

Thank you! I've already changed the blown driver. Currently trying to revive the board via USB and without any drivers attached. It will be a challenge, but I am able...

I've successfully replaced the 1769 CPU and burnt the smoothieware bootloader with an Segger J-Link via SWD. Could'nt get the STM-V2 to work, though. https://twitter.com/pregopm/status/1288855798223962112 AFAIK the method using the...

@Pixel-Soup The SKR 1.3 and SKR1.4 are using an LPC176**8**, thus the smoothieware (LPC176**9**) bootloader will not work. The 1.4 **Turbo** uses the LPC176**9**, same as the Smoothieboard (IIRC).

We have 2 x 10A MeanWell power supplies that feed the stripe in question every 4-5m. I think you have a very good point and I will check this as...

I was thinking on how the ESP will get unstable if the LDO is the "thing" that delivers the 3.3V for it. Nevertheless, I will test to go to 4.9V...

I think there is. But as the ESP's are installed near the led stripes there is nothing attached to the serial console. I'm not sure if the same "problem" occurs,...