code8buster

Found the problem! Setting MOVE_CACHE_LOW to 0 (disabling move cache segment time adjustment) restored the normal function to the Rostock Max. Now that I've seen it performing normally, I can...

I changed the setup() to try to eliminate any issues with point 1, and moved TCXO into the begin method call. I'm doing something wrong here because I now get...

My bad, attached the heading of a sketch that will compile and upload. The behavior stays the same in the first case, save for the fact that in the last...

Not sure that the modules themselves are functionally different, but if I just switch these pins to the following (which are the pins specific to the 900m22s I/O on that...

 This is the device. Its schematic is linked in the original issue. Under those conditions numerically listed, I get an initial -20 wrong modem, followed by -2 chip not...

Interesting, indeed leaving essentially no GPIO free. I jumped the NRST pin on the 900m30s to SD_DAT2 on the back of the board, GPIO12 Unfortunately, that made no difference with...

I have verified the NRST drops to low-voltage, and that there is activity on the vspi bus. According to the manual, this is the valid condition for chip-reset trigger. Vcc...

Yes, I'll give this board another try and report back.

GPIO pre-transfer timeout, is it connected? GPIO pre-transfer timeout, is it connected? SX126x not found! (5 of 10 tries) RADIOLIB_SX126X_REG_VERSION_STRING: 0000320 20 00 00 00 65 26 0d 80 90...

These opts should only be used if the /boot partition is fat32 for EFI Otherwise with bios + ext4 this fails. Ah this is already pointed out by #252