Santiago Hormazabal

I've started using this project as the basis for my [exploration and repurpose](https://github.com/cocus/orckit-566-80c188-fw) of an old telecom board that has a 80c188. I've managed to flash Wichit Sirichote's [x86Bug Monitor](http://www.kswichit.com/C188/c188sbc.htm)...

Oh I see. I checked again, and seems there's no support for the 8N2 on the software serial :( there are other libraries that should support it, but since you...

So, having a look at the original SoftwareSerial.cpp from Arduino, I can see that they calculate the bit delay with this code: ``` // Precalculate the various delays, in number...

what's the V25? an embedded sibiling of the NEC V20? So, for the 8018X (the embedded ones), I created a startup ROM code that enables the UART, GPIOs and such,...

I have my loader set up so it calls ELKS at E000, but it also contains the ROMFS a little bit afterwards, so starting at E000 until the very start...

Hi, I would vote for the same thing. It doesn't need to be MCS51 specific; since __sfr and __at are also used in other platforms (at least, I'm using them...

What's the old driver pack that "works"? I have installed it recently with the latest edk2-msm (https://github.com/edk2-porting/edk2-msm/releases/tag/2301.1) and latest WOA-Drivers (2210.1-fix), and usb doesn't work (it can charger, but nothing...

> It may be too late now, but USB-OTG worked when I used v2.0rc2 when I installed it. Yes, I've used the old one. Not sure what changed. But certainly...

Hello, where's that PDF? I can't find it!

> > Do you know if there is any wiring information about this SPI interface? Keen to understand how it is wired. > > Hello @cocus, do you have any...