clehn8ok

Hi terjeio, I think i have a similar issue, and wanted to ask for your expertice. When i do my first M6 Toolchange (not tool length offset is set) ,...

It is: ` grblHAL ; 1.1f.20220325 ; [OPT:VNMZHS2,191,1024,3,0] ; [NEWOPT:ENUMS,RT+,HOME,ES,TC,SED,ETH] ; [FIRMWARE:grblHAL] ; [NVS STORAGE:*FLASH] ; [DRIVER:iMXRT1062] ; [DRIVER VERSION:220325] ; [DRIVER OPTIONS:USB.1] ; [BOARD:GRBLHAL2000 - PRINTNC] ; [AUX IO:4,1,0,0]...

I don't have any code loaded, i am just at machine 0,0,0. I type t1 m6 in the CLI, and it will do the first tool change with the short...

 But since i can't get even get the solo M6 command working, i didn't pursue the gcode generated by the grblhal PP

Yes exactly, i start at z0, which is the spindle all the way up. Yes when my i start the m6, with the spindle further down it works. Then it...

Has this something to do with the hardcoded defines, mentioned earlier? `// NOTE: only used when settings.homing.flags.force_set_origin is true #ifndef LINEAR_AXIS_HOME_OFFSET #define LINEAR_AXIS_HOME_OFFSET -1.0f #endif #ifndef TOOL_CHANGE_PROBE_RETRACT_DISTANCE #define TOOL_CHANGE_PROBE_RETRACT_DISTANCE 2.0f...

Ok thank you very much for the quick response! i'll try the pull off distance first, but it will change the distance of all limitswitches, there is no explicit setting...