chriswal

mmu2s V1.0.6 boots to normal mode and printer sets it to stealth mode (because its set in the printer that way) of course you have to switch it in the...

is it possible that the load is too high in the teflon tubes? i changed mine to tubes with 3mm inner width because of the load the 2mm version produced...

Hi, the resistance of the power plug is important, but normally you end up with all leds flashing when there is a problem with it. The plugs should not be...

which version you are using? as i remember this works on 1.0.6 and the previous one .. the mmu stores the last loaded filament in the eeprom only the idler...

yes the printer doesnt know where the filament is loaded. but it should not be possible to move the idler away from the loaded filament unless the finda doesnt detect...

the mmu2 has only a small set of error detection. 1 the driver got reset / power failure / overheating 2 after pushing forward there is no change in the...

in this case the error is on the mmu2 (but not detected on the mmu2) but the error you see on the mmu2 (led blinking) is sent from the printer...

sorry i know that it should not matter if you put it into the MMU2 issues. There is such a lot of MMU2 error handling missing in the Printer firmware....

yes you are right its a feature ..but this feature repeats the not handled error ;-) yes if you look at the code the mmu doesnt send anything to the...

> the mmu2 has only a small set of error detection. 1 the driver got reset / power failure / overheating 2 after pushing forward there is no change in...