chibisuke

@lemmingDev I can confirm this issue, but this is out of scope on this repository. However there is an easy fix to it. (https://github.com/blackketter/ESP32-BLE-Combo/pull/2)

Thx for your reply. Unfortunately I'm pretty sure it got nothing to do with wireing, sind I switched around the cabels, steppers and drivers already. The only thing that made...

In standalone mode the problem is gone, so it definitly got somthing to do with the UART config that is sent. Any more ideas on how to procede to get...

In the default setup it only happens on the extruder port. If I setup any other port (x,y - didn't test z) as having UART ID 3 on the driver,...

@markniu only for testing to troubleshoot it, but reverted it completely. @Moorviper yea, but if it would be a wiring issue why would it only occure on a stepper connected...

Still no idea where this is comming from. Its not appearing in standalone mode, but as soon as I set the UART jumper in the board the problem is there,...

In the meanwhile I switched to an SKR 1.4, with the same stepper drivers, same cabels, same steppers and the same settings. There it works without any problems. So either...

There have not been any major upgrades for more then 2 years now. @JohnSully can you please confirm (or deny and if whats the timeline) KeyDB is dead?

so do I understand it correctly, that even tough this problem is from 2018!! and there have been numberous attemps by people to fix it, all those get rejected because...