Cameron D. Dockstader
Cameron D. Dockstader
In case it makes a difference, the 'Printing time' value is not reduced during power cycling. It's just the 'Filament printed' value.
Yes, exactly. Read the value, power off, wait a bit, power on, read the value again, value has decreased.
Are you running v0.92.3.0? Maybe it's already fixed in the latest code? Maybe it only occurs after printing and then powering down? I have 230 minutes left on a print,...
Any idea when master will be ready for 1.0A? The read me still indicates it's only for the first generation of printers... I did notice it no longer says not...
Oh sweet, thanks!!! I'll be upgrading later today then! Wahoo!
Cool, thanks for the heads up!!
Just wanted to confirm, with v0.92.3.0, I turned on the printer this morning and recorded the filament printed value to be 302.5. I then printed a 4.5 hour job that...
After reflashing v0.92.3.0 just to be sure I ran another test and noticed something peculiar. I started the print at 314.3, and a few seconds before completing the printed filament...
It appears the latest and greatest still has the issue. I started a print at 314.9, estimated use of .5. Just before completing the print, the value was 315.4, but...
At the very end of the print log, I found this: READ: Printed filament:315.91m Printing time:5 days 6 hours 46 min So I belive that's where the 315.9 is being...