burneme

I had this effect that it stops mostly in the first layers suddenly. This effect took place after the changes "Removed unnecessary cache queue for managing PLR feature". When I...

> are you using the latest TFT fw with also advanced ok feature enabled on both TFT and mainboard? If so, try to simply disable advance ok on TFT only...

**@digant73** I checked with old FW, print is pretty good using the same (unmodified) SD-card. Obviously not corrupted. Current baudrate is 115k2 towards the main board, I'm sceptical about lowering...

> Just yesterday night I had some errors (also at the beginning of a print exacly when the LED was switched on). Do you have a LED strip on your...

Since it is a communication problem, I will build at first a small unit which is able to log both sides of a serial connection and log it. Need it...

Last Evening I tried it with the youngest version (TFT70, precompiled from here), stopped after approx. 10% of 1.8MB gcode-file. My previously announced Box which can log both sides of...

I had similar problems with communication between TFT35_laser Ver.1.0.3 on MKS TFT35 V1.0 and a two axis Arduino Uno board based board. I could manage to define extra buttons to...

Sending directly from Lightburn-> USB (comport) works fine. Will log the data sent from MKS TFT35 when printing from SD-Card, compare and report here.

 The low-level of the TXD (from TFT35) ist still bad because of the load of the CH340 chip, even it is not connected to the pc. I have to...

The easiest way to hold permanently connection from TFT35 or the USB (CH340) was just to set an small switch where I can select either the TX pin of the...