borland1 comments

Repositories
Issues
Comments

Results 4 comments of


                                            borland1

[FR] Manual probe. Use saved z value

Not sure what your saying would make it easier? Are you referring to this code snippet in `Configuration.h` ? ``` 1910 #if ANY(MESH_BED_LEVELING, AUTO_BED_LEVELING_UBL, PROBE_MANUALLY) 1911 // Set a height...

SD card is not reading...

Disabled by default... Configuration.h ``` * SD CARD * * SD Card support is disabled by default. If your controller has an SD slot, * you must uncomment the following...

Gyro orientation...

I think the 3D orientation standard was drawn on the side of a bridge in the UK by William Hamilton in 1883, but someone thought it was graffiti and erased...

Retraction Tower Part Has Bridges That Seem Unnecessary For Tuning Retraction Speed and Distance

Well the part seems fine with the exception of the bridging. There are already numbers on one side of each level and detents between levels, so the bridging really doesn't...