Brad Wojcik

I agree with OP. I currently use pyenv but I regularly use other programming languages as well and wanted to give asdf a try. This repo was very hard to...

@azareth012 is there a difference in model/revision of the two USA PSUs you tested? It's hard to read the far left one in the image. After reading this thread I'm...

> internally there are some different components, today I have tried 4 usa PSU and 1 jap PSU, the problem persists only with 1 of the usa PSU, I have...

Not sure if this is entirely related, but in recent versions of pyenv I've noticed that when running `eval "$(pyenv init -)"` in my zshrc, anytime I run `which pyenv`...

Thank you for explaining! I thought I was losing my mind. I hadn't noticed that behavior before and thought either my setup/config was wrong, or the tool had changed 😄

With the only other difference being SP2 vs SD Gecko, it appears you're probably right. Either SP2 issue, which I'll test further when I get the new one/an SD Gecko....

> Note that there is two revisions of the EON GCHD Mk-II. I know there are firmware updates, and I know there was an original EON GCHD prior to Mk-II....

I had the same issue and like others above I was able to resolve by shortening the wires! All 5 of my wires are now 10-12 cm. My pico is...

Actually now that I've played with it a bit more I'm seeing inconsistent boot behavior. The gamecube doesn't consistently boot Swiss. More often than not, it boots to native bios....

Thanks for the replies! I've ordered a (hopefully) better SD2SP2, a side loading one for access with gameboy player. I might try an SD Gecko also to see if there...