bogde
bogde
i just tested the current code on Feather 32u4 and it seems to work well, you may want to give it another try. i connected the clock pin to pin...
there is no get_average. scale.get_units(5) makes 5 readings and then outputs the average of those 5 readings. to make sure your code gets built and uploaded correctly, you should change...
can you post your sketch? i'm trying the HX711SerialBegin demo (MacOS, Arduino 1.8.1) on a "D1 mini WeMos.cc" and seems to be working after cleaning up the setup section.
i just tried v1.6.9 on windows and it seems to work too, again, after removing most of the test code from the setup section. i'm going to update to 1.8.1...
i dont seem to be able to reproduce you're issue, but i'm not sure we're using the same boards. i removed your oled display calls and replaced them with console...
if i were you, i would first isolate the issue by commenting out the oled display code, to test @fishersolutions tip. btw, thanks David for chiming in. or you can...
you shouldnt comment out the is_ready code. you probably get 0.0 readings because the chip is indeed not ready. according to @fishersolutions tip, you should comment out the definition of...
I too apologize for the hassle @nseidle and @MIKMAI had. I was not aware merging the changes would have such an unwanted impact. I do think that these changes add...
sorry for the delay, did you fix the issue yet? are you sure your wiring is correct, especially the correct wiring of the clock and data pins?
@HamidSaffari thanks for your feedback. what hardware did you use?