blackfister

Hi there, I have made worms by adding “kwakers”. It gives you any sizing of thread. You can use either metric or imperial. For metric module to imperial diametral pitch,...

Thanks, I’ll give it a try

Still won’t thread as desired…. I’ll post pictures of config

Hi, I’m new to this, as I understand, the readings, for example will show a 1,00 for a 1mm thread pitch, and a 0,05 mm/rev feed, correct?

I have installed your version, and doesn’t seem to work, no action with + - , weird. While inhaling cloughs els version again, I lost threading, it advances, but in...

If I was to use the “thread to shoulder” , how should I proceed? I’m using a nema34 stepper, Thanks

Finally got it working! custom threads, angle position However when I use shoulder, as it retracts, I loose sinc with the thread. Shoulder set, start set. Nut engaged. anyone with...

Hi Kwakers, thank you for answering, could it be that it’s loosing steps as retracting? I’m testing at low speed, 42rpm. everything being used as it should. Shoulder set, nut...

> Hi Kwakers, as for the shortage sinc I did mention before, while retracting on shoulder mode, when lo load is applied, the carriage retracts perfectly. I attach vidrio with...

Everything is working excellent! For threads above 9,99, can a table be created? Should I change spindle/ encoder ratio? Thank you