Thomas

The problem with this approach is that these tools are not consistent over the online ones. Maybe they introduce some bugs or are less efficient. I can't rely on them...

I'm open to pull requests if they are well tested and commits are not too invasive (don't try to change syntax or fix something at the opposite of the PR).

Same problem here, by displaying modbus error, I get this message : Incomplete message received, expected at least 2 bytes I updated my Debian but changed nothing else electrically speaking...

I finally fixed the problem by using the xr driver version 1a instead of 1c... strange ! (I use Dumasto install it)

> > I finally fixed the problem by using the xr driver version 1a instead of 1c... strange ! (I use Dumasto install it) > > Can you please Elaborate...

>  Thanks for your check but it's not the same hole ^^

Ok strange then because my inserts are not 1.5mm below the surface... I will check if my screws have the correct size

Thanks for your reply @wile-e1 , I have checked again M3x12, it fits, now that the counterbore holes have been "done" by longer screws. The screws measure 12mm with no...

Same problem here... Data are not sent to HA, only the topics... Here are the errors : ``` pi@raspberrypi:~/bt-mqtt-gateway $ sudo ./gateway.py -d 2019-06-26 20:17:44,867 INFO bt-mqtt-gw gateway.py:39: - Starting...

By double-checking, I saw the problem is not the same... I'll have to investigate :s