TheBionicbone

I had this same issue, the fix was that I did copy the MODELS folder, but also needed to copy the RADIO folder from the OpenTx SD Card to the...

Leave with me and I will check this weekend. I suspect further code is required to remove your "human" labels after the ID number for the export.

Can you update the Python like this ? I have just created many logs for SavvyCan with this code. def saveTableToFile(self, table, path): if path is None: path, _ =...

@Kwieeciol it would if I had got GitHub set up correctly

I did some analysis, so far I think it is being cropped in the Arduino either as part of the read or the wirte back.

I know this is an old thread but have to mark +1, it really needs to be half the current size. I'm using the windows 64-bit Version 0.9.3  The...

@Phil-Mitton @dmn8s5 @per1234 @Loongle @ruziev-dev @JeseRamanantsoa @mattia424 Did anyone find an alternative CAN driver that will compile on the S3, my particular application is to use 2 * MCP2515, I...

Hi @RealTadango , can you confirm if LView works with EdgeTx, personally I have v2.7.1 installed ? I did try, it intially showed me a corrupt screen and then goes...

@RealTadango thanks for the support, I'll try again later. Thinking about it, it is possible the logs were probably pre-covid for the model I had selected.

Hi Bodmer, Awesome library you have created here, I found it some years ago and have been itching to play more, but time was an issue, I'm sure you also...