Manta-M8P
Manta-M8P copied to clipboard
bigtreetech
There's a small typo in the English user guide on page 36 in section 6.2.3. The word "klipper" is mispeleled as "kliiper" in one of the commands given. 
My guess is that it is the V1 board that has been uploaded here since the CAN connector and its paired 120R termination resistor are missing from the board. I'll...
I'm looking for some info regarding DFU mode, usualy boot + reset then release reset. on that board version we have boot 0 and boot 1 so which one one...
Please add `interpolate: False` to the configuration for the TMC2130 drivers in the example file. It will prevent people having the issue of slanted prints. It may be necessary in...
I have problems with the CSI ports for camera and display. Neither the PI Global Shutter Camera nor the display connected to the CSI port work with the Manta M8P+CM4....
I have been attempting to connect a camera via the 4-pin USB port that is clearly labeled in the manual. I see the pin layout is as shown below (relabelled...
Hello, is possible to connect EBB board for each Extruder or only one can be used? I'm building custom multicolor printer. I'm using M8P v1.1 with RPi CM4 module running...
On the M8P V2 pinout diagram the canbus pins are marked as TX and RX. This is the wrong protocol and and does not translate to over to canbus High...
Hello I am having a problem with my Manta M8P V1. The neopixel LEDs light up partially or they light up in the wrong color or do not go out...
Having an issue where the CB1 will not boot via power from the M8p, M8P shows 12,5,3.3 volts are powered via the indication Led. The CB1 does boot via USB...
