Manta-M8P
Manta-M8P copied to clipboard
bigtreetech
Good day. I can get the cb1 to boot but the firmware.bin is never picked up by the sdcard reader. I've tried DFU mode but it always errors out: `biqu@BTT-CB1:~/klipper$...
Board: Manata M8P v2 MCU: CB1 with eMMC After flashing the M8P board with a new klipper config, I lost connectivity with my EBB42 v1.2. So, I reflashed the bootloader...
Hi all Tried to flash my board via DFU and followed the instructions of the manual. All went quite well the way as shown in the manuel included the error...
I have just installed a CM4 onto a (V1.0) M8P I can SSH into the board just fine and have compiled the firmware. When I use a SD card to...
Hello, can anyone please upload the V2 bootloader, I think my board has a dmaged bootloader/ mcu, I just got three days ago without having the chance to use it...
can not get the extruder to work. if i plug the extruder motor in to one of the axis’s motor it moves . so motor is good. i have the...
I started with a Manta M8P v1.0 a year ago and had issues driving a 63-LED strip of SK6812 LEDs (RGBW). The first 20 or so would illuminate as expected,...
**I lost serial connection.** root@BTT-CB1:/home/biqu/klipper# ls /dev/serial/by-path/ ls: cannot access '/dev/serial/by-path/': No such file or directory --- wget https://github.com/bigtreetech/Manta-M8P/blob/master/V1.0_V1.1/Firmware/M8P_bootloader.bin dfu-util -d ,0483:df11 -R -a 0 -s 0x8000000:leave -D ./M8P_bootloader.bin **Does...
Connecting an ADXL345 to SPI1 on my Manta M8P causes the MCU to not boot. It seems like the bootloader is conflicting with some other device on SPI1 on boot....
Got ff vs e5 as always. The board doesn't recognize the accel chip no matter what. Tried uncomment the spidev0.0 then specify in config, and it's not a wiring problem...
