HermitCrab
HermitCrab copied to clipboard
bigtreetech
It was bought up on the facebook group that STEP files of the die castings for the Hermit Crab V2 etc were not yet available only step files of the...
This may be a bit long winded.. but here goes. I got a hermit crab V2 canbus from BTT a few weeks back. Flashed it with Katapult and then klipper...
I have the setup of Manta MP8 with BTT CB1 and eMMc 16. Problem is that I can't find any setup instructions. Is any buddy having the same problem. Please...
I cannot get the HermitCrab board to connect to my computer to flash the firmware. I have tried three different micro USB-b cables in three different ports. The board was...
I'm getting an error every time i try to extrude filament ``` Unable to obtain tmc extruder phase TMC 'extruder' reports error: DRV_STATUS: 40140020 s2vsb=1(LowSideShort_B!) cs_actual=20 stealth=1 Once the underlying...
Hi! I recently purchased a Hermit Crab & an H2 extruder for my Ender 3 v2. I'm having a problem determining how to connect the Hermit Crab to my 4.2.7...
So far in designing cases for the Distribution Board and the Can-Hat I have noticed that both step files for the boards are different than the actual hardware. I'm crossing...
I can’t find any documentation on wiring and setup for running a hermetcrab on my hurakan
None of the documentation lists a max power load for items attached to the tool plate.
Requesting the 3d model files for the Canbus version be fixed to download correctly. Only raw text is output into the browser instead of downloaded the STEP file.
