CB1
CB1 copied to clipboard
bigtreetech
OS System image for CB1
Hello everyone, When I turned my 3d printer back on, I can no longer connect to klipper. my BTT Pi v1.2 is visible on the wifi network but I can...
When running make menuconfig from klipper, what options do I have to select to update but use the default card? https://imgur.com/gcr1KSL This part is different from the manual and now...
The nand-sata-install command even starts but doesn't do anything after all it runs very quickly and if you remove the micro SD it won't boot
Hello, how do I install and configure the PITFT43 DIP on the BIGTREETECH PI4B Adapter V1.0 and CB1 ?
CB1 WiFi
So I wrote the CB1 image. In the system.cfg file I put in my Wifi info. I did the 2.4ghz since not sure if 5 supported. I am looking for...
OS: Klipper Kernel 5.16 07/12/23 image Device: CB1 in BTT Pad7 I haven't seen this posted else where, but I've noticed a TON of errors in dmesg while trouble shooting...
Upgrade the CB1 image to Debian 12 Bookwoom to allow use of /dev/serial/by-id/
I want to control GPIO on the CB1. I saw that it is possible with [gpiod](https://wiki.radxa.com/Gpiod). In my case, pin names don't appear but there are more than 300 pin...
**Setup:** - Windows 10 - CB1 eMMC v1.1 - Downloaded sunxi-fel.exe on 19 Aug 2023 from this GitHub (along with all other necessary files). **Issue:** I connect my BigTreeTech CB1...
It is somewhat annoying, but it is almost always difficult to press the elements or there are random ghost touches
