SSH connection is impossible even visible on wifi

[JEOBDX]

Hello everyone,

When I turned my 3d printer back on, I can no longer connect to klipper.

my BTT Pi v1.2 is visible on the wifi network but I can no longer connect.

I reflashed viaUsing balenaEtcher with the latest version v2.3.4 and put the wifi parameters in the config.cfg file but without success.

Do you have any ideas ?

thank you in advance for your help

[manotroll]

inside the system.cfg file you must uncomment #hostname="BTT-CB1" and what is inside the "" can be changed, do not use special characters and put the wifi password in its normal place You have to see what username/password you are using for the image

[JonLaRue]

Hello I have had this issue as well. I have found for whatever reason, power cycling the BTT Pi over and over can help. I can currently connect via IP to mainsail with my phone.. but for whatever reason I cannot with my PC... I am using the same bookmark. I am also unable to SSH into the Pi...

[manotroll]

Check if network isolation is not enabled on the router

[JonLaRue]

Changing AP Isolated from "No" to "Yes" did not fix. It did break my entire home network... Thanks.

[manotroll]

then return to No But can you ping? What program are you using to make the ssh connection?

[JonLaRue]

Factory Resetting Wifi Network and then manually selecting IP address has solved the issue.

[JEOBDX]

HI ALL,

What ever reason , I flash again and succed to connect ssh after "uncomment #hostname="BTT-CB1" and what is inside the "" can be changed, do not use special characters and put the wifi password in its normal place " in the CFG file as @manotroll said in comment before.

I continue to work with and install Klipper to see if everything all right ....