BIGTREETECH-OCTOPUS-Pro

BIGTREETECH-OCTOPUS-Pro copied to clipboard

Unable to connect to board

1

I'm using Marlin 2.0.9.3 and windows. I have been successful in uploading firmware but when it comes to connecting the board to my computer (I'm using pronterface) it won't connect....

stewcop23

PE11/GND reversed in Octopus Pro color PIN diagram

3

The PE11/GND pins are reversed in the color version of the pin diagram for Octopus Pro. The other, older version, is correct.

ph1ltep

ntc100k setup

2

hi, how configure the jumper for a NTC 100K for an ender 3 mk8 hotend stock,please ? in the doc, i can look for a PT100 / PT1000 with 2,3,or...

mystone51

Hey, i am using Octopus Pro with TFT70, and whenever i configure PT100 with the board in marlin bugfix, it shows "no printer attached" if i use normal thermistor in...

Akds4877

2nd Tactile button on v1.0.1

2

Can not find any description for a new 1.0.1 pro board (429) where is explained the function of that tactile button switch next to the SD slot and aligned with...

Budavaril

using vscode to flash firmware does not work

2

Hi, I am wondering if it is possible to flash the firmware on my Octopus Pro V1.0 with vscode/platformio using the USB-C connection. this is my platformio.ini setting: [platformio] src_dir...

Majestix1970

Hello , I got maybe an issue , by connecting everything to my board. 4 stepper drivers for 3 axis and extruder I was doing some work on my heatbed...

TheRephaim

How to connect 2nd LED? Which port has alternative 5V data

1

Looking for an direct alternative to connect a second LED bar on the board besides the neopixel port PB0

renekar

Hi all, I would like to connect my NEMA 23 to the Octopus Pro. I have the drivers for them which are (by title) TB6560. I would like to know...

luca920

Octopus PRO dual Y axis

5

I am trying to set the board to have dual Y axis, but am struggling in understanding how. Which config lines should I modifiy?

luca920