Mostafa Eissa
Mostafa Eissa
@alfrix thanks a lot for your quick response, I have tried several times, always failing with the same error. Even with a fresh image of Armbian. I will try your...
same error again: Installing collected packages: MarkupSafe, jinja2 Successfully installed MarkupSafe-2.1.1 jinja2-3.1.2 Collecting matplotlib==3.5.0 Downloading matplotlib-3.5.0.tar.gz (35.0 MB) |████████████████████████████████| 35.0 MB 10 kB/s Preparing metadata (setup.py) ... done WARNING: Requested...
it is indeed pip 21.3.1. I will try to upgrade & keep you posted.. thanks a lot.
same error even after updating pip: Creating virtual environment Requirement already satisfied: numpy==1.21.4 in /home/pi/.KlipperScreen-env/lib/python3.9/site-packages (1.21.4) Requirement already satisfied: jinja2==3.1.2 in /home/pi/.KlipperScreen-env/lib/python3.9/site-packages (3.1.2) Requirement already satisfied: MarkupSafe>=2.0 in /home/pi/.KlipperScreen-env/lib/python3.9/site-packages (from...
Oh sorry, I didn't realize that! I tried that, so it kept downloading & discarding versions..
but version matplotlib-3.4.3.tar.gz did the trick.. not sure how would that impact the final product
@valeriiyurchenko what’s driving me nuts is that I was able to install it several times before using the same method & hardware 🤯
@valeriiyurchenko thank you, that worked for me too!
Motor 3; since it says M3A & M3B.
> So @shawnchr's hotfix helped a bit to make it work. > I still had to change my wireless connection via "sudo nmtui". The CB1 tried to dial in using...