badger707

Have not tried this firmware yet, but we had great success with BHT-8000 thermostat with this fork [here](https://github.com/fashberg/WThermostatBeca/issues/89)

@grbasta I'm in the same boat, have 2 of these thermostats... I have tweaked a little bit the code for this model and recompiled from source, finally got it working...

So my initial thoughts was that main issue in HA was about MCUID output format... It seems there is something else incorrect/wrong in payload or its formatting, and HA keeps...

> It surely works, as I've based my own firmware on codes found in this repository, I can even send weather infos to it ;) > ![WhatsApp Image 2021-01-13 at...

@grbasta - I think these lines has to be baked into correct place within firmware, and then there must be some side process which is sending/pushing updated forecast information remotely...

@grbasta -- one of ways to compile firmware would be to install Visual Studio Code, then go to Extensions and install PlatformIO IDE. This will install all additional things needed...

@nwaelti -- thanks for notes. Agree, digesting all Tuya protocol would be preferred way to go, I've read through the sections mentioned by @f3nix (thanks!). Overall this makes sense (I...

With such issue, which is not related to this firmware, I guess you'll have better luck trying to check reddit, there is huge community for home automation which might already...

For disconnects from AP (*1), it could be that your ISP router wifi signal is not strong enough at that spot and your thermostat keeps dropping off. Try to move...

Give us better understanding of your setup. This model is known to be working perfectly with this firmware...