bacintom

Hi! Thanks for yout replies! In my case, it is a SK Hynix. The mystery thickens. I somehow managed to take a photo with a readable part number, let me...

@trabucayre to be honest I don't understand much about RAM but here's my take about the size issue: I found a datasheet of H5TQ1Gx3EFR-xxx modules In my case the exact...

@e-yes As long as I set nrows=8192 (the quickest way to test is, take an unmodified master and set the value in MT41J128M16) it will report the correct amount 128MiB,...

@nickoe thanks I hadn't noticed something was pushed to litedram master. With @trabucayre 's commit, the bios passes the sdram check successfully. No need to tweak with mode register commands...

Hi, I got over my liftoff issue. I did the following : -update all litex. Patches about supporting tang primer 20k have been pushed recently. -check the files in the...

@Sujunyou cd and ls work fine in this linux, so I'm not sure what your problem is... Are you sure you set up a linux?... If you just build litex...

@sususjysjy The issue 4 is not solved, I just disable the check that fails by editing gowin_gw1n.py, it's also fully explained how to do it in my first post...

@sususjysjy I'm confused, I was replying to @Sujunyou there, are you the same person? I get the same error as you nowadays if I use litex_boards, the error means the...

@sususjysjy I can build with make.py and enable sdcard instead of spisdcard. It will build successfully. The size difference must be somewhere else? But sdcard+linux-on-litex-vexriscv doesn't work on master with...