artayasa
artayasa
Hii iam very apriciate to your project. For now i looking like this driver for my pmsm servo 220v 5A. With ABZ encorder 2500ppr. It is posible to used?? And...
### Variant None ### Control type None ### Control mode None ### Description Is this suport step/dir interface for cnc sir??
It is suport for bldc or pmsm sir??
It is suport step dir interface sir??
Iam very happy when vesc suport step/dir intervace, so the vesc not only control sketeboard or onewheel only, also posible to used for robotic, thank you, i hope soon will...
It is posible to add step dir interface? So the bldc or servo motor can use for cnc
is it possible to change the n-channel mosfet ncep60t20 to the n-channel mosfet irf3205. because irf mosfet is much cheaper in my country.
Hi mate what happen is this?? I fillow the procedure but still get that error. Error on the image. 
Hii this is posible to control potition with step/dir signal?? And also i not used drv but i used like ir2101 ot same HIN and LIN
Hi sir, im interest with your project. It is posible to change the igbtdriver with this chip, IKCM30F60GA. I see datasheet almost same. And also this suport step/dir control?? If...