aris-kimi
aris-kimi
Hi @cnieves1 , i am not sure if polarity marking should be placed at fab layer, but i think a `T` pointing at the right direction simplifies the drawing. Fab...
Hi @cnieves1 , i will allow this since there are some similar symbols, and probably i am going to propose a complete lib rework after migrating. I will full review...
I am not sure about name, everything else is great. @chschlue , does that have to be full part number `KPBD-3224SURKCGKC` or we are ok with current naming `KPBD-3224`? If...
Hi @cnieves1 , after @chschlue 's input on the linked PR i think you should clear fab layer from internal graphics, and also aligne silk line for pin1 (and shorten...
Fix all the mess i caused, updated all important images. Edit: `Maybe in this case something like BGA packages, with letter for the column and number for the line will...
I think this one is finaly ready.
Hi @aracosta1 , i noticed that you didn't use round pads and drill holes, i am wondering if this is acceptable since datasheet gives holes' dia. 
Yes @myfreescalewebpage , i will start this today, but later when i finish work.
Hi @aracosta1 , sorry for the delay. I do have those comments about this footprint. - [ ] fab layer line width must be 0.1mm - [ ] fab layer...
Thank you for your reply. You can add it here yes. I think it is too big but i missed that KLC rule, so you are correct we should keep...