Bogdan Kecman

any news on this? what is the MCP chip used to connect the other side? MCP23017? MCP23S17? (i2c or spi or ?) are you using the same firmware as ergodox...

I know how it works (the jerk) it's just that I don't own a single printer that uses jerk so I can't test the implementation hence I never tried to...

it's not that complicated but the problem is "how is it implemented" in each firmware. the junction deviation thing I copied from the smoothieware code so for e.g. I know...

@oysteinkrog I would still love to have support for JERK if anyone (@eyal0 started doing it already :D ) would do it, but great if Marlin implements jdev too :)...

it's hard to see the curve from the numbers :( .. maybe sharing the data (csv?) ? gcodestat on this graph is the jdev one? not your fork with jerk...

> This would still take just as long as printing, though. yup, so since it will take the time, better to use it to make something, let printer print :D...

> If the only difference between estimate and actual is the starting temperature it's a big factor for sure, that's why I put the M117 codes in the code so...

~~~ Move exceeds maximum extrusion (201.137mm^2 vs 44.000mm^2) ~~~ not crashing any more as I fixed the printer config and put some sanity check but still tries to extrude a...

@SoftFever attached, sorry for delay @igiannakas note that I have 1.8.1 on win11 and 1.8.1 on macos, this happens only from win11, when I slice on mac, same version, same...

I reproduced it on MAC too :( huge extrusion during WIPE .. not sure why would it try to push filament out during wipe ?! especially this much filament ~~~...